Menu

Connect with us

Stainless steel water inlet hose 10cm-80cm

price:USD$55.00
discount 70% in 2018-10-22 to 2018-10-24
price: USD$ 38.50
freight :USD$18.00,(Express)
freight :USD$7.00,(Postal parcel)
views:0
Search Similar or mail to saler or send message to saler

Pay with PayPal, PayPal Credit or any major credit card

This product is made of top grade material and introduced into the advanced production technology of the United States. It has been tested by modern testing equipment. It has the characteristics of innocuity, explosion proof, cold resistance, high temperature resistance and long service life.

Characteristic:The water temperature range can be between -40 and 120 degrees centigrade.

Pressure range:25kgf/c square meters 40kgf/c square meters

This special soft 304 stainless steel hose bending forming is easier, home water heater, kitchen sinks, mop pool water, toilet water choice oh

Manufacturer commitment:There are quality problems within three years!!!

Optional length of pipe:10CM,20CM,30CM,40CM,50CM,60CM,70CM,80CM,90CM,1M,2M,3M。Thread specification:4 points X4 points

Applicable scope:Faucet hot and cold water inlet connection, water heater hot and cold water connection, toilet water inlet connection and so on.

Usage method:The length of the bellows is adjusted according to the required distance of the installation, and then the pipe body is bent according to the specific position, and the nuts at both ends are screwed into the connecting wire mouth, so as to adjust the pipe body to make the best shape. Installation sequence: check appearance and seal ring - Installation seal check - water test. Accurate installation of stainless steel telescopic bellows, the service life can reach 10 years. The best five years to replace the 1 seal ring

Installation notes:

1) shut down water valve before installation.

2) first of all, check whether there is accidental damage in the process of storage and transportation, and whether the fittings are complete.

3) shall not use sharp metal and other hard objects extrusion, impact and collision pipe body.

4) the product should not be close to the fire source to prevent the sealing ring from deformation and failure.

5) after installation, open the water source valve for trial use, carefully observe the nut connection and the pipe body whether there is leakage phenomenon (at least one hour after the observation once).

6) the product must be installed in a place with floor drain and smooth water outlet.