discount 70% in 2018-09-20 to 2018-09-22
price: USD$ 2.10
freight :USD$7.00,(Postal parcel)
Minimum Order Quantity:5
Search Similar or mail to saler or send message to saler
◆◆,Name200-4C iron head
◆◆,Characteristic：(Don't forget to take a few more eyes here. Oh, oh, it's good for the baby you care for
1Pure copperT2The heat transfer rate is very high and the heat transfer is very fast
2Special alloy layer electroplating, high temperature resistance, corrosion resistance, strong electromagnetic induction
3It is suitable for lead-free soldering
4The tin is strong and non oxidizing
1When soldering head is used for lead-free soldering, the service life will be reduced a lot. It is recommended to use low temperature welding as far as possible to meet the requirements of welding and prolong the life of the soldering iron head
2After soldering the iron head for a period of time, the surface will appear oxidation layer, it is recommended to use special tools to remove, otherwise it will not eat tin phenomenon, the iron head does not eat tin,80%The factor is related to your habits
3，In, many buyers bought iron head, iron head will think of the purchase compared with the previous, not very easy to use, the main phenomenon is not tin, then anger, anger or dealer,
In fact, this is wrong, you buy the iron head if purchased with the previous product is not the same batch of brand products, only the life may change greatly, generally speaking, the beginning of the use of the time is still good.
The main reason for this phenomenon is that the user did not first dispose of tin on the head surface of the iron head when the user just used it,
Because no matter what the iron head factory, all in the iron head surface by using the flux in the melted tin tin dipping inside.
The use of each different flux component, acid, alkaline, or neutral, if you happen to be the same kind of buy, the tip your very good, on the contrary, the flux and buyers use flux may not dissolve, and then not tin phenomenon. Serious will let the iron head.
Therefore, the new iron head must be installed on the electric iron heating, and so the pre melted tin, cleaned with a clean sponge.
If you use solder wire with flux, make up the solder wire directly
If you need external flux, dip the soldering flux first and then make up the solder immediately,
No matter what nature of solder wire, tin must pay attention to uniform coating, so that tin will not produce the phenomenon, and the more the better use.
4The iron head must not be dry, otherwise the life will be very short