WTP10-32 cobaltiferous imported material machine tap screw hole tapping for lower chip JIS made in Japan
The thread tap is mainly used for thread cutting of various through hole materials. In general the apex wire tapping with hand tapping for straight grooves are the same, but at the front end of the cutting part with spiral grooves with special design, so as to push the rotating chip discharged from the hole bottom. This is because the tip of the wire of rotary discharge chip function, in addition to keep clean in order to reduce the resistance of groove cutting outside, and can avoid the damage caused by the wire tapping chip.
discount 70% in 2018-09-24 to 2018-09-26
freight :USD$7.00,(Postal parcel)
Search Similar or
mail to saler or
send message to saler