discount 70% in 2018-09-18 to 2018-09-20
price: USD$ 199.50
freight :USD$7.00,(Postal parcel)
Search Similar or mail to saler or send message to saler
Dispensers announcement: details can be linked to the background or mobile phone contact
A postal package in Jiangsu, Zhejiang and Shanghai
The rest of the region is full of 599 packages
When you buy a saw blade, choose the tooth type according to the size and material of the material you saw. For the durable saw blade, the key is to pick the teeth.
If you have any questions, please contact with the background or telephone.
Material diameter 50mm, with 4/6 teeth
Material diameter 50mm-150mm between 3/4 teeth
Material diameter 150mm above, with 2/3 teeth
Saw pipe seamless steel pipe with good tensile tooth
The tooth types are usually：2/3 3/4 3/4 teeth; teeth, flat teeth, 4/6 teeth, 3/4 teeth turtle; 4/6 flat tooth
Special notice for installation and use of band saw blade (important)
1. before installation, check the direction of the saw tooth in detail so that the cutting direction is consistent with the rotation of the band sawing machine.
2. check the pattern and number of teeth of the saw band / inch, whether it is consistent with the material and size of the cutting material.
3. adjust the tension of the saw band should be moderate, too tight, easy to break the belt, too loose easy to break teeth and cutting oblique.
4. cutting fluid according to the cutting material adjustment concentration, carbon steel quasi thin, stainless steel quasi thick. And regular replacement.
5.All new saw blades must be run in before cutting. Refueling, will raise the blade to a certain height, avoid severing saw.
Running in of new saw blade
The new saw blade must be run in before the official use. The service life of a saw blade without running in or without running in is 1/3 or less of a running saw blade.
The feed rate during 1. running in is 20-30% of normal feed rate.
2.The running in period is about 5-10% of the expected life.
3.The running speed should be 20-30% during normal cutting.
4.Sawing belt starts from running in period and gradually transits to normal cutting. Don't increase the feed rate and the belt speed each time.
Such as 45# steel, 100 round round rod cutting 20 knives can be normal cutting. If the cutting material has high hardness or large cross section, the number of running in tool can be reduced correspondingly. On the contrary, the number of running in tool should be increased.
Explanation of return:
Because the band saw blade is easy to be worn out, the band saw blade can be replaced without trial machine. The machine has been tested, and the original quality of the saw blade has been lost because of the wear and tear, and the original quality will not be replaced