discount 70% in 2018-10-19 to 2018-10-21
price: USD$ 180.60
freight :USD$7.00,(Postal parcel)
Search Similar or mail to saler or send message to saler
1, rated voltage: 220-240V
2, frequency: 50-60Hz
3, rated current: 10A
4, set the starting pressure: 1.5Bar
5, the maximum working pressure: 1Mpa
6 、 interface screw: G1 external thread
7, the highest operating temperature: 70
8, protection level: IP65
After the device is connected to the circuit, the green light emitting diode is energized, and the yellow light emitting diode is turned on, indicating that the water pump has been started.
The pump runs for a few seconds, filling the entire system pipe to achieve the required pressure.
If the system fails to achieve the desired pressure within the next few seconds, the red LED "fault" lights; at this time, turn on the faucet, hold down the "start" button until the red light-emitting diode is extinguished. Once the "start" button is released and the faucet is turned off, the pump will be closed when the pump maintains the maximum pressure.
The interior of the device adopts unique design, which can be used to automatically control all the operation of the pump.
When accidents such as water shortage, water inlet pipe blockage fault by special operation, the device can identify the fault at the same time, the "fault" red light; at the same time, a device will stop signal is transmitted to the water pump to prevent water damage due to water pump running water.
After correcting various faults causing system congestion, the system can be restarted by pressing the "start" button.
Matters needing attention：
The controller is installed vertically and installedPay attention to the sealing of panel, inlet and outlet, in case the water in the control box is short circuited, and the control box is damaged.