Connect with us

Plastic expansion bolt, nail Extrusion board, phenolic board insulation nail, 80*600 nails for exterior wall insulation

discount 70% in 2018-10-20 to 2018-10-22
price: USD$ 17.92
freight :USD$18.00,(Express)
freight :USD$7.00,(Postal parcel)
Search Similar or mail to saler or send message to saler

Pay with PayPal, PayPal Credit or any major credit card



performance parameter

On the basis of JG149-2003 exterior insulation standards; single insulation nail loading force no less than 0.3KN


The diameter of the anchor pipe is 0.7-0.8


Thermal conductivity "0.06"


The outer anchor nail; 50MM


The temperature is -40 degrees --70 degrees


The insulation nail is a special anchor for external wall insulation, which consists of galvanized screws, nylon tubes and fixed discs. According to the thickness of the insulation layer, divided into a variety of specifications. Widely used in architectural decoration. The thermal insulation nail made in our factory is widely used in the insulation layer of the building. Has anti-aging, anti temperature shock, anti-corrosion, cold and heat; high bearing capacity, high pressure, good tensile properties; after loading is not easy deformation, corrosion proof, insulation characteristics, noise and good vibration absorption. Easy installation, hammering, no special installation tools. Galvanized screw is a good solution to corrosion problems, good durability, and nylon material heat transfer performance is low, there is no cold bridge in winter, high efficiency and energy saving.


Product category

Split insulation nail and conjoined insulation nail


Now the insulation nail on the insulation nail Market is basically one, and it is easy to use.


At the same time, the new standard 158-2004 has also been implemented the new standard is;


Bearing capacity of single insulation nail; 0.8KN


Thermal conductivity 0.004


The outer anchor nail "56MM


Arrangement of exterior wall thermal insulation nail. The number of anchor system installation extruded board exterior insulation; 1-10 layer average 6 / square meters, the 11-20 layer average 7 / square metre 21-26 9 / square meters. Any area of more than 0.1 square meters of single block wrench must add anchor, depending on the number and shape of the scene and in the corner, under the eaves; Yang, around the edge of the hole, should increase the anchor density, the distance is not greater than 300 mm from the base edge of not less than 60mm