The expansion hook hit the ground or on the wall of the hole, hook the expansion nut tightened with a wrench, bolt to go outside, and outside of the metal sleeve is not moving, so the bulk of the bolt under the metal sleeve to be expanded, so that the whole fullness in the hole, the expansion hook pumping out the.
Product useIt is generally used for fastening of wire rope, chain, etc. on concrete, brick and other materials. But its fix is not very reliable,If the load is greater vibration, may loose, so it is not recommended for the installation of ceiling fans.
1. Choose a drill screw expansion pipe of the same diameter and expansion, installation again wall punch in the electric drill, the depth of the hole and the best bolt of the same length, and then the expansion screw hole to knock together, remember:Do not unscrew the nut to prevent the bolt from falling into the hole when the hole is deep.
2. The expansion bolt tight and loose and then unscrew the nut to tighten the nut feeling 2-3 buckle, then the fixed objects with holes punched in a fixed alignment bolt mounted on the outside of the shim or spring washer to tighten the nut.
As shown in the illustration, the installation method of expansion hook is illustrated:
Installation of M6 expansion hook, diameter of 10MM hole, in accordance with the outer diameter of the tube wall hole. Two, the expansion tube part to enter the wall, as long as the thread part is long enough, the deeper part of the casing, the more solid.
NeedBe carefulYes, the expansion screw must be installed on a relatively hard substrate, soft and easy to fall out of place, unstable, such as the wall of the gray seam.
Attention points of expansion screw installation:
1, drilling depth: the relevant information on the expansion is the length of the tube, but we found that the construction of the concrete in the hole depth is not enough, may give the residual debris, so you'd better than the expansion pipe length of about 5 mm deep. As long as you are larger than or equal to the length of the expansion tube, the length of the expansion bolt left in the ground is equal to or less than the length of the expansion tube.
2、Drilling diameter: M6 drilling diameter is 10mm,The drilling diameter of M8 is 12mm
The drilling diameter of M10 is 14mm,The drilling diameter of M12 is 16mm
3, the expansion hook on the ground, of course, the more hard the better, it also depends on the force you need fixed object. Install inConcreteThe stress intensity is five times as much as that in the brick.
4. After installing a M6/M8/M10/M12 expansion hook in concrete correctly, its maximum static force is 120kg/170kg/320kg/510kg.