Connect with us

The original crack 936969968 iron knife head pointed elbow horseshoe iron head KIDC Ju

discount 70% in 2018-09-23 to 2018-09-25
price: USD$ 10.50
freight :USD$18.00,(Express)
freight :USD$7.00,(Postal parcel)
Search Similar or mail to saler or send message to saler

Pay with PayPal, PayPal Credit or any major credit card

Iron head maintenance:
1. welding work
Must first clean wet sponge, then squeeze out excess water, so that it can make the iron head to get the best cleaning effect. If you use a clean sponge and non wetting, the iron head damaged lead tin.
2. when welding
Following the order of the iron head welding can get solder protection and reduce the rate of oxidation.
3. welding work
First, the temperature at about 250 DEG C, and then clean the iron head, add a new layer of tin for protection. (if you use a non soldering station temperature control, put the film cut off, let the iron head temperature slightly reduced after tin.)
4. note
A. try to use low temperature welding
High temperature can make the iron head accelerate oxidation, reduce the tip life. If the tip temperature above 470 degrees Celsius, the oxidation rate of it is two times 380 DEG C.
Not too much pressure on B.
In welding, no pressure is too large, otherwise it will damage the iron head deformation, as long as the iron head can fully contact solder joints, heat can also choose the appropriate transfer, iron head can also help in heat transfer.
C. often keep the tip on the tin
This can reduce the chance of oxidation of iron head, the iron head is more durable. After use, should be the tip temperature slightly lower after adding new solder, the tin layer has better anti oxidation effect.
D. keep clean clean iron oxide, timely
If there is a black oxide iron head, iron head may not be on the tin, this must be cleaned immediately, the tip temperature of about 250 DEG C to clean up, clean with a clean sponge iron head, and then the tin, repeated action, directly to clean up oxide.
E. with low flux activity
High activity or corrosive flux can accelerate the corrosion of the iron head in the heat flux, so should choose low corrosion.
Note: do not use sandpaper or hard clean iron head.
F. to put iron received in the welding of formwork should be carefully placed in the soldering iron welding metal frame appropriate, so as to avoid collision damage caused by iron head.