Commodity  encodingIn tact.
Product characteristics: 1, composed of zinc alloy die casting, connector with high quality 304 stainless steel.
2, the hinge is installed in a door leaf, the opening angle of 180 degrees, after the closure of the hinge is not exposed, beautiful and generous.
3, after the closing of a door hinge, door gap is less than 1mm, can be used for folding door.
4, the hinge bearing as follows: according to each door with 3 Calculation
According to the specification, determine the number of hinges, and draw lines at the appropriate place.
According to the painting line, opening on the door, the hinge seat into the door leaf. And fixed with screws.
Open hole in the corresponding position of the side plate,
Raise the door leaf, the hinge seat can be inserted into the hole of the side plate, and screw.
Adjust the position of the hinge. To open the door and window is smooth, uniform clearance.
Tighten all the screws.
Maintenance of products:
1, to prevent the emergence of bumps in the handling.
2, when cleaning, use dry cloth or cotton dust, with a dry cloth stained with a little anti rust oil wipe, finally with dry cloth and keep dry
3, should prevent the erosion of acid alkali salts and dip.