Connect with us

A sharp 5050/5052 pneumatic nail gun pull Mini rivet Rivet Gun Riveter riveting tool

discount 70% in 2018-08-20 to 2018-08-22
price: USD$ 291.20
freight :USD$18.00,(Express)
freight :USD$7.00,(Postal parcel)
Search Similar or mail to saler or send message to saler

Pay with PayPal, PayPal Credit or any major credit card

This is a pneumatic tool that needs to be connected to the air pump (air compressor) to be used.





Common troubleshooting methods for pneumatic nail guns:
1, pull continuous nail or pull many times to break.
2. After the nail is broken, the nail is not retreated.
3. The action of the switch without pulling nails is only out of the air.

The 1. oil cylinder is short of oil stroke; the claw and the push rod are worn; the claw sleeve is too close to close the claw.

The 2. guide is not matched; the claw sleeve is too close to open.

The 3. switch O ring is broken; the piston O ring is broken.

1. add hydraulic oil to the cylinder; change the claw and push rod; adjust the claw sleeve to the right position.

2. replace the matching guide; after adjusting the claw sleeve to the appropriate position, it will naturally fall out of the back with a broken nail from the guide to the nail.

3. change the O ring.


The nail gun is an efficient mechanized hand-held tool

The main body adopts high quality synthetic material, which has the characteristics of light weight and easy operation.

The free vibration technology, operation comfortable, prolong the service life of.

Through the spring circuit and air loop, fast oil back design, so as to improve work efficiency.

Noise reduction design, operation noise is small, meet the requirements of environmental protection.

The compressed air is effectively used by the vacuum switch.